Page top


Omron uses cookies to improve your experience on this website. By continuing to use the website, you hereby agree to our Privacy and Cookie Policy

Lead Contents

Power Controller: Detecting Disconnection for Multiple Heaters

FAQ No. FAQ01969

Primary Contents


What are the conditions for detecting disconnection for G3PX-2[][]EHN-CT Power Controllers that detect disconnection for multiple heaters?


The disconnection detection conditions are listed below.

1. The load current must be 1 A min.

2. The CT detection current must be 30% or higher of the rated maximum load current.

Note:Increase the number of CT turns if the CT detection current is 30% or less.

3. Up to five heaters can be connected (20% multiple heater disconnection detection characteristics)

Care must be taken because the following phases are not detected by heater disconnection detection.