Transistor Remote I/O Terminals with Connectors (8/16 Points)
last update: November 27, 2013
Item | SRT2-VID08S
SRT2-VID08S-1 |
SRT2-VID16ML
SRT2-VID16ML-1 |
---|---|---|
Input current | 6 mA max./point at 24 V, 3 mA max./point at 17 V | |
ON delay time | 1.5 ms max. | |
OFF delay time | 1.5 ms max. | |
ON voltage | 15 VDC min. (Between each input terminal and V: NPN. Between each input and G: PNP.) | |
OFF voltage | 5 VDC max. (Between each input terminal and V: NPN. Between each input and G: PNP.) | |
OFF current | 1 mA max. | |
Insulation method | Photocoupler | |
Maximum number of inputs | 8 | 12 |
Number of circuits | 8 points/common, 1 circuit | 16 points/common, 1 circuit |
Item | SRT2-VID08S
SRT2-VID08S-1 |
SRT2-VID16ML
SRT2-VID16ML-1 |
---|---|---|
Rated output current | 0.3 A/point | 0.3 A/point (2-A common) * |
Residual voltage | 1.2 V max. | |
ON delay time | 0.5 ms max. | |
OFF delay time | 1.5 ms max. | |
Leakage current | 0.1 mA max. | |
Insulation method | Photocoupler | |
Number of circuits | 8 points/common, 1 circuit | 16 points/common, 1 circuit |
Communications power
supply voltage |
14 to 26.4 VDC |
---|---|
I/O power supply voltage | 20.4 to 26.4 VDC (24 VDC +10%/-15%) |
I/O power supply current | Sensor connector: 2.4 A max., MIL connector: 2.0 A max. |
Current consumption * | 50 mA max. at 24 VDC |
Noise immunity | Conforms to IEC61000-4-4, 2 kV (power lines) |
Vibration resistance | 10 to 150 Hz, 1.0-mm double amplitude or 70 m/s2 (50 m/s2 for SRT2-ATT02) |
Shock resistance | 200 m/s2 |
Dielectric strength | 500 VAC (between insulated circuits) |
Ambient temperature | Operating: -10°C to 55°C (with no icing or condensation)
Storage: -25°C to 65°C |
Ambient humidity | Operating: 25% to 85% (with no condensation)
Storage: 25% to 85% |
Mounting strength | No damage when 100 N pull load was applied in all directions (40 N load for SRT2-ATT02) |
Terminal strength | No damage when the following loads were applied:
Communications connector: 100 N Sensor connector: 40 N MIL connector: 100 N |
Screw tightening torque | Communications connector: 0.25 Nm |
Node address setting | Settings made at DIP switch (set before supplying power for Slave communications) |
Weight | Approx. 75 g max. |
last update: November 27, 2013